![]() May also be used for the discontinued Marshall ™ Termination is 0.187" (4.8mm) push-on terminals. Has 4 electrical terminals on back of switch SWITCH, MARSHALL™, HARTKE™, OTHERS, LARGE WIDE BLACK Rocker portion feed the power transformer, while the terminals behind the "0"Īre connected to the incoming power source. Works properly, make sure that the terminals directly behind the "1" on the Red lighted version - easier to see than the tiny LED Marshall™ originally Has 4 electrical terminals on back of switch. Marshall™ MINI ROCKER SWITCH FOR Marshall™ MG SERIES - LIGHTED Has 4 electrical terminals on back of switch.įace of switch marked with "0" and "1" for on/off. ORIGINAL Marshall™ MINI ROCKER SWITCH FOR Marshall™ MG SERIESĭPDT Mini Rocker Switch. 1/4" push-on terminals, or solder directly to terminals. Standby switch has 4 electrical terminals on back of switch. ![]() Internal neon lamp powered by either 125VAC or 250VAC. Lighted power switch has 4 electrical terminals on back of switch. SWITCHES, FOUND IN Marshall™ JCM SERIES & OTHERS WITH MULTIPACK! THIS SET CONTAINS BOTH the POWER AND the STANDBY ROCKER JCM-900, early versions of the TSL and DSL series, see the SW-490 switch.) (For the similar standby switch used in previous model series such as the Versions of the DSL201 and DSL401, JVM410H, JVM215C, etc. Used in the later versions of the TSL100, TSL122, DSL100, DSL50, DSL40, later ORIGINAL Marshall™, FOUND IN Marshall™ JVM, JCM2000, DSL, TSL SERIES ROCKER SWITCH, BLACK, USED AS STANDBY SWITCH IN Marshall™ JCM SERIES & OTHERS Power switch button for the second ValveState series, POWER SWITCH BUTTON FOR VALVESTATE SERIES II AMPS Itĭoes have the anchoring pins on the front bracket which are soldered to the PC On top (marked in the photo with yellow arrows) to the PC board. NOTE: This switch does not have the 4 pinĬonnections on the bottom, so it is necessary to run wires from the 4 terminals Marshall reference numbers S540, S1603, and SW1008. Power switch for the second ValveState series, POWER SWITCH FOR VALVESTATE SERIES II AMPS Also found in theĭSL-5, DSL-15, and the Mode 4 MF-350. Later versions of the TSL100, TSL122, DSL100, DSL50, DSL40, later versions of ORIGINAL Marshall™, FOUND IN Marshall™ JVM, DSL, and JCM2000 SERIES Used in the Power switch, see the SW-491 switch above. Internal neon lamp powered by 125VAC.įor newer JCM900 and JCM2000 series with 4 terminals on the Hasĥ electrical terminals on back of switch. ![]() To show you how to easily wire the new switch. The terminal locations are a mirror image of the ![]() For those switches with 5 terminals, this These switches were originally made by Arrow for Marshall,īut have been unavailable for many years. Most JCM800 and late JMP series power switches have 5 terminals on the back of the Does your old Marshall™ power switchįrom the JCM800 era have five terminals? See the SW-492įOUND IN Marshall™ JCM800 and LATER JMP SERIES - 5 For most JCM800 models, see the SW-492 below.įor the JCM2000 and JVM series, see the SW-493. SWITCH, LIGHTED POWER, ORIGINAL Marshall™, FOUND IN Marshall™ JCM900 SERIESįor JCM900 series.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |